annex

Updated Crossflash Firmware for Linksys WAG200G

This entry was posted in Tips and tagged annex firmware linksys update on

openwag1.4The Moho’s Crossflash Firmware (that converts annex B to A and vice versa) for Linksys WAG200G, wich are based on Open WAG200 have been updated to version 1.4

If you already had installed any prior version of these firmwares, to update to the new version you must select the same annex as your router is, before the prior update.

(For example: you have a annex B router and you had installed the Crossflash Firmware B to A v1.2 to covert it to annex A, so, to upgrade to v1.4 you must install the Crossflash Frimware B to A v1.4, NOT the A to B.)

 
For downloads and more info see Linksys WAG200G convert annex B to A and vice versa post.
 
(more…)

Linksys WAG200G convert annex B to A and vice versa

This entry was posted in Tips and tagged annex convert firmware linksys on

For a long time, a very good Linksys WAG200G gathering dust in a corner, because was ANNEX B and still unusable on my PSTN line… until now! I made a risky decision, to flashing the router with a custom firmware, which convert it to ANNEX A functionality.

Searching the net I found two firmwares, menioned by Moho at adslgr.com forum, which are based on OpenWAG200 project, and convert annex a routers to b and vice versa.

WARNING: THIS IS EXPERIMENTAL, OPEN BETA SOFTWARE. YOU ARE USING THIS SOFTWARE AT YOUR OWN RISK. YOUR ROUTER MAYBE BRICKED!

To avoid bricking your WAG200:

  • Language setting must be set to english prior to flashing the firmware
  • Do not flash via remote internet connection or wireless connection – flash ONLY from wired LAN PC
  • If flashing will take more than the progress bar is telling you, wait patiently for about 10 minutes before manually restarting the router….

If you are not so lucky and you got a bricked router, read Unbricking WAG354G tutorial from Marco Vedovati, his advice is likely to work and at WAG200.